Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE REAR SEAT CUSHION ASSEMBLY


    B132600E01
  1. Detach the seat cushion's 2 front hooks from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat for the other hook.

  1. Detach the seat cushion's rear hook.

  1. Remove the seat cushion.



3. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE REAR SIDE SEATBACK FRAME LH


    B076393E02
  1. Remove the bolt.

  1. Detach the claw and remove the frame.



5. REMOVE REAR SIDE SEATBACK FRAME RH

HINT:
Use the same procedures described for the LH side.



6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH


7. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
  1. Remove the bolt and disconnect the floor anchor.



8. REMOVE BACK DOOR WEATHERSTRIP


9. REMOVE TONNEAU COVER ASSEMBLY


10. REMOVE REAR FLOOR NO. 2 BOARD


11. REMOVE REAR FLOOR NO. 3 BOARD


12. REMOVE REAR FLOOR NO. 4 BOARD


13. REMOVE DECK FLOOR BOX REAR


14. REMOVE DECK FLOOR BOX LH


15. REMOVE REAR FLOOR NO. 1 BOARD


    B132619E01
  1. Remove the 2 bolts and the 2 rope hooks.

  1. Using a clip remover, remove the 2 clips.

  1. Using a screwdriver, detach the 5 clips and remove the floor board.

    HINT:
    Tape the screwdriver tip before use.



16. REMOVE DECK TRIM COVER REAR


    B076395E02
  1. Using a screwdriver, detach the 4 claws and remove the trim cover.

    HINT:
    Tape the screwdriver tip before use.



17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH


    B079224E02
  1. Remove the screw and 2 bolts.

  1. Using a clip remover, remove the clip.

  1. Using a screwdriver, detach the 6 claws and 2 clips, and remove the side panel.

    HINT:
    Tape the screwdriver tip before use.



18. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



19. REMOVE TIRE PRESSURE WARNING RECEIVER ASSEMBLY


C128501E01
  1. Disconnect the connector.

  1. Remove the bolt.

  1. Using a clip remover, detach the clip and remove the receiver.