Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


B074044E02
  1. Detach the 2 claws and 4 clips, and remove the instrument panel register.



3. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER


B074045E02
  1. Remove the 2 screws.

  1. Disconnect the hood lock control cable.

  1. Detach the 4 claws and 5 clips.

  1. Disconnect all connectors and remove the instrument panel finish panel.



4. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY UPPER


B074046E02
  1. Detach the 3 claws and 4 clips.

  1. Disconnect the connector and remove the instrument panel finish panel.



5. REMOVE NO.3 INSTRUMENT PANEL REGISTER ASSEMBLY


B074047E02
  1. Detach the claw and 5 clips.

  1. Disconnect the connector and remove the instrument panel register.



6. REMOVE NO.4 INSTRUMENT PANEL REGISTER ASSEMBLY


B074048E02
  1. Detach the 6 clips and remove the instrument panel register.



7. REMOVE NO.2 INSTRUMENT PANEL REGISTER ASSEMBLY


B074049E02
  1. Detach the 2 claws and 4 clips, and remove the instrument panel register.



8. REMOVE MULTI-DISPLAY ASSEMBLY
  1. Remove the multi-display .



9. REMOVE TIRE PRESSURE WARNING ECU


C128498E01
  1. Disconnect the connector.

  1. Remove the bolt and ECU.