GARAGE DOOR OPENER SYSTEM > REGISTRATION |
| 1. REGISTER TRANSMITTER CODE |
Register a system transmitter code in the garage door opener system.
Select a garage door opener switch for transmitter code registration.
Press and hold the selected switch for 20 seconds. The garage door opener will enter registration mode.
After the garage door opener has entered registration mode, bring the original transmitter of the system to be registered within 1 to 3 inches of the garage door opener and press and hold one of the garage door opener switches. Then press the original transmitter switch.
If the transmitter code registration was successful, the LED of the garage door opener flashes at a cycle of 5.6 Hz. If no malfunction occurs, release both the garage door opener switch and the original transmitter switch.

![]() |
Erase the transmitter codes in the garage door opener clear mode.
Press and hold the left and right switches of the garage door opener for 20 seconds. The LED will begin to flash at a cycle of 5.6 Hz. Releasing the switches will end clear mode.

Low power mode:
If a garage door opener switch is held for 100 seconds or more, the garage door opener will enter low power mode to economize on power consumption. When the garage door opener has entered low power mode, the LED turns off.