Home › STEERING › POWER STEERING › STEERING GEAR

STEERING GEAR > DISASSEMBLY

for Preparation Click here



1. FIX STEERING GEAR ASSEMBLY


    G028295E03
  1. Using SST wrapped with protective tape, secure the steering gear in a vise.

    SST
    09612-00012  

    HINT:
    Remove and reinstall the SST as needed.



2. REMOVE TIE ROD END SUB-ASSEMBLY LH


    F040050E12
  1. Put matchmarks on the tie rod end LH and rack end.

  1. Remove the tie rod end LH and lock nut.



3. REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the LH.



4. REMOVE STEERING RACK BOOT CLIP
  1. Using pliers, remove the 2 rack boot clips (for RH and LH).



5. REMOVE NO. 2 STEERING RACK BOOT CLAMP


    G029447E02
  1. Using a screwdriver, unstake and remove the clamp.

    NOTICE:
    Do not damage the boot.



6. REMOVE NO. 1 STEERING RACK BOOT CLAMP

HINT:
Use the same procedures described for the No. 2 rack boot clamp.



7. REMOVE NO. 2 STEERING RACK BOOT


8. REMOVE NO. 1 STEERING RACK BOOT


9. REMOVE STEERING RACK END SUB-ASSEMBLY


    G028298E04
  1. Using 2 SST, remove the rack end (for LH side).

    SST
    09922-10010  

    NOTICE:
    1. Use SST in the correct direction as shown in the illustration.
    2. Securely hold the steering rack.



    G028299E04
  1. Using 2 SST, hold the steering rack LH side and remove the rack end (for RH side).

    SST
    09922-10010  

    NOTICE:
    1. Use SST in the correct direction as shown in the illustration.
    2. Securely hold the steering rack.