POWER WINDOW CONTROL SYSTEM > Manual Up / Down Function does not Operate on Passenger Side Only |

| 1.CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY FRONT RH (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the P14 switch connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| P14-4 - Body ground | Power switch ON (IG) | 10 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY FRONT RH |
Check the regulator switch (Click here).
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (REGULATOR SWITCH - REGULATOR MOTOR) |
![]() |
Disconnect the P14 switch connector.
Disconnect the P19 motor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P14-1 - P19-1 | Below 1 Ω |
| P14-3 - P19-2 | Below 1 Ω |
| P14-1 or P19-1 - Body ground | 10 kΩ or higher |
| P14-3 or P19-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY FRONT RH |
Check the regulator motor (Click here).
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (MASTER SWITCH - REGULATOR SWITCH) |
![]() |
Disconnect the P17 switch connector.
Disconnect the P14 switch connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P17-13 (PU) - P14-5 | Below 1 Ω |
| P17-15 (PD) - P14-2 | Below 1 Ω |
| P17-13 (PU) or P14-5 - Body ground | 10 kΩ or higher |
| P17-15 (PD) or P14-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||