Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Power Window can be Operated After Power Switch is Turned OFF Even if Operative Conditions are not Met

for Preparation Click here


DESCRIPTION

The body ECU keeps power supplied to the power window regulator master switch and the regulator switch for 43 seconds after the power switch is turned OFF. However, the body ECU will cut power to the master switch if: 1) either front door is opened, 2) a signal from either of the front door courtesy light switches is input to the ECU within the 43 seconds, or 3) 43 seconds have passed.

WIRING DIAGRAM


E124635E01


INSPECTION PROCEDURE

1.CHECK OPERATION FUNCTION AFTER POWER SWITCH IS TURNED OFF
  1. After turning the power switch OFF:

    1. If either front door is opened within 43 seconds but the power window can still operate, proceed to A.

    2. If 43 seconds pass but the power window can still operate, proceed to B.



B
REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
A


2.READ VALUE OF TECHSTREAM (COURTESY LIGHT SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG) and press the Techstream main switch ON.

  1. Read the Data List according to the displays on the tester.

    Body ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Dor Cty SW
    Driver side door courtesy light switch signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P Dor Cty SW
    Passenger side door courtesy light switch signal / ON or OFF
    ON: Passenger side door is open
    OFF: Passenger side door is closed
    -

    OK:
    ON (door is open) appears on the screen.



OK
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY
NG


3.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY


    B058556E13
  1. Measure the resistance.
    Standard voltage 
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Switch body
    Pushed
    10 kΩ or higher
    1 - Switch body
    Not pushed
    Below 1 Ω



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
OK


4.CHECK WIRE HARNESS (COURTESY LIGHT SWITCH - JUNCTION BLOCK)


    E124641E01
  1. Disconnect the D7*1 or D8*2 switch connector.

  1. Disconnect the 1D junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D7-1 - 1D-21 (DCTY)
    Below 1 Ω
    D8-1 - 1D-24 (PCTY)
    Below 1 Ω
    D7-1 - Body ground
    10 kΩ or higher
    D8-1 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK (BODY ECU)