Home › ENGINE › 1NZ-FXE STARTING › POWER SWITCH

POWER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


B074044E02
  1. Detach the 2 claws and 4 clips, and remove the instrument panel register.



6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


B074045E02
  1. Remove the 2 screws.

  1. Disconnect the hood lock control cable.

  1. Detach the 4 claws and 5 clips.

  1. Disconnect all connectors and remove the instrument panel finish panel.



7. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


B074046E02
  1. Detach the 3 claws and 4 clips.

  1. Disconnect the connector and remove the instrument panel finish panel.



8. REMOVE POWER SWITCH


    A127732E01
  1. Push the 2 claws and then remove the power switch.