BACK DOOR > ON-VEHICLE INSPECTION |
| 1. INSPECT BACK DOOR |
Check that the clearance measurements of areas A to D are within the standard range.

| Area | Specified Condition | Area | Specified Condition |
| A | 6.6 +-1.5 mm (0.260 +-0.059 in.) | C | 4.6 +-1.5 mm (0.181 +-0.059 in.) |
| B | 5.8 +-1.5 mm (0.228 +-0.059 in.) | D | 4.8 +-1.5 mm (0.189 +-0.059 in.) |