HOOD > ADJUSTMENT |
![]() |
| 1. ADJUST HOOD SUB-ASSEMBLY |
![]() |
Adjust the hood's position.
Loosen the 4 hinge bolts on the hood side.
![]() |
Move the hood and adjust the clearance between the hood and front fender. Make sure that the clearance is within the standard range.
Tighten the hood's hinge bolts after the adjustment.
![]() |
Adjust the cushion rubber so that the height of the hood and the fender are aligned.
![]() |
Adjust the hood lock.
Remove the 6 clips and radiator support opening cover.
![]() |
Loosen the 3 bolts.
Adjust the hood lock position so that the striker can enter it smoothly.
Tighten the bolts and nut after the adjustment.