POWER SWITCH > ON-VEHICLE INSPECTION |
| 1. CHECK POWER SWITCH MODE CHANGE FUNCTION |
Check the function of the power switch.
Check that power switch mode changes in accordance with the conditions of the shift position and brake pedal.
| Shift Position | Brake Pedal | Change of power switch mode (Arrow "→" means 1 press of power switch) |
| P | Released | OFF → ON (ACC) → ON (IG) → OFF (Repeated) |
| P | Depressed | OFF → Hybrid system starts |
| P | Depressed | ON (ACC) → Hybrid system starts |
| P | Depressed | ON (IG) → Hybrid system starts |
| P | Depressed | Hybrid system operating → OFF |
| P | Released | Hybrid system operating → OFF |
| Any position other than P | Released | ON (ACC) → ON (IG) |
| Any position other than P | Depressed | ON (ACC) → ON (IG) |
| Any position other than P | Released | ON (IG) → OFF after shift position switched to P (shift-linked OFF function) |
| Any position other than P | Released | Hybrid system operating → OFF after shift position switched to P (auto P control function) |
| Any position other than P | Depressed | Hybrid system operating → OFF after shift position switched to P (auto P control function) |
Check if power switch mode changes without pressing the power switch.
With power switch mode ON (ACC) and the shift position in P, pull out the key. Check that power switch mode changes from ON (ACC) to OFF automatically.
With power switch mode ON (ACC) and the shift position in P, wait for at least 1 hour. Check that power switch mode changes from ON (ACC) to OFF automatically.
| 2. CHECK INTERLOCK FUNCTION |
Insert the key into the key slot, and change power switch modes and shift position according to the table below. Check whether or not the key is locked in the key slot.
| Power Switch Mode | Shift Position | Key Status |
| OFF | P | Not locked in |
| OFF | Any position except P | - |
| ON (ACC) | P | Not locked in |
| ON (ACC) | Any position except P | Locked in |
| ON (IG) | P | Locked in |
| ON (IG) | Any position except P | Locked in |
| READY (hybrid system ON) | P | Locked in |
| READY (hybrid system ON) | Any position except P | Locked in |
| 3. CHECK INDICATOR CONDITION |
![]() |
Check the power indicator on the power switch.
Check that the power indicator illuminates and changes colors according to the table below.
| Power Switch Mode | Indicator Status |
| OFF | OFF |
| ON (ACC) | Green illumination |
| ON (IG) | Amber illumination |
| Hybrid system ON | OFF |
| Push button start system malfunctioning | Flashes continuously in amber |