Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The stereo jack adapter sends an external device sound signal to the radio receiver through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio receiver, or speakers.

WIRING DIAGRAM


E107216E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (RADIO RECEIVER - STEREO JACK ADAPTER)


    E107217E02
  1. Disconnect the R5 receiver connector.

  1. Disconnect the S30 adapter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S30-4 (AUXO) - R5-19 (AUXI)
    Below 1 Ω
    S30-3 (ASGN) - R5-16 (ASGN)
    Below 1 Ω
    S30-2 (ARO) - R5-15 (ARI)
    Below 1 Ω
    S30-1 (ALO) - R5-17 (ALI)
    Below 1 Ω
    S30-4 (AUXO) - Body ground
    10 kΩ or higher
    S30-3 (ASGN) - Body ground
    10 kΩ or higher
    S30-2 (ARO) - Body ground
    10 kΩ or higher
    S30-1 (ALO) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE