Home › BODY › ENGINE HOOD / DOOR › BACK DOOR SUPPORT

BACK DOOR SUPPORT > DISPOSAL

for Preparation Click here


HINT:
Use the same procedures for the RH side and LH side.

CAUTION:
As metal debris may be blown outward by the gas, you must:
  1. Wear protective glasses.
  2. Cover the area being cut.

NOTICE:
The gas is colorless, odorless and harmless.



1. DISPOSE OF BACK DOOR STAY ASSEMBLY LH


    B065104E02
  1. Horizontally fix the stay in a vise with the piston-rod pulled out.

  1. Using a metal saw, gradually cut any area between A and B (shown in the illustration) to release the gas.
    Specification: 
    Area
    Measurement
    a
    80 mm (3.15 in.)
    b
    20 mm (0.80 in.)