Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CRUISE CONTROL MAIN SWITCH


I102362E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 3
    +RES
    210 to 270 Ω
    -SET
    560 to 700 Ω
    CANCEL
    1,380 to 1,700 Ω
    ON-OFF button is on
    Below 1 Ω
    ON-OFF button is off
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.