Home › ENGINE › 1NZ-FXE EMISSION CONTROL › PURGE VALVE

PURGE VALVE > INSPECTION

for Preparation Click here



1. INSPECT PURGE VSV


A086290E02
  1. Inspect the resistance.

    1. Measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      26 to 30 Ω at 20°C (68°F)

      1. If the resistance is not as specified, replace the purge VSV.



    A086292E01
  1. Check the ventilation.

    1. Check that there is no ventilation from port F when air is applied to port E.
      If there is ventilation, replace the purge VSV.



    2. A086293E01
    3. Apply battery voltage across the terminals.

    4. Check that there is ventilation from port F when air is applied to port E.
      If there is no ventilation, replace the purge VSV.