Home › ENGINE › 1NZ-FXE EMISSION CONTROL › PCV VALVE

PCV VALVE > INSTALLATION

for Preparation Click here



1. INSTALL VENTILATION VALVE


    A128678
  1. Install the ventilation valve onto the cylinder head cover.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }



2. INSTALL ENGINE WIRE


    A087341E01
  1. Install the brake master cylinder reservoir cover to the cylinder head cover.



    A087340E01
  1. Install the wire harness and brake master cylinder reservoir cover with the 3 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect the fuel injector connector and ignition coil connector.



3. INSTALL AIR CLEANER ASSEMBLY


    A087334E01
  1. Install the air cleaner with the 2 bolts and tighten the clamp.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf } for bolt
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf } for clamp



    A086911E01
  1. Connect the No. 1 air cleaner inlet to the air cleaner case, and then tighten the clamp.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



4. INSTALL ENGINE ROOM NO. 2 RELAY BLOCK


    A087418E02
  1. Install the relay block with the 2 bolts.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 in.*lbf }



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
  1. When the warning light is illuminated or the battery has been disconnected and reconnected, turning the power switch may not start the system on the first try. If so, turn the power switch again.
  2. With the power switch's power mode changed to ON (IG), disconnect the battery. If the key is not in the key slot during reconnection, DTC B2799 may be output.



    A088356E01
  1. Connect the battery negative cable, and then tighten the nut.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



6. INSTALL REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Install the floor board, and then attach the 4 claws.



7. INSTALL REAR DECK FLOOR BOX


    A088354E01
  1. Install the rear deck floor box to the vehicle.



8. INSTALL REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Install the floor board, and then lock the 2 cover knobs.



9. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.