Home › ENGINE › 1NZ-FXE EMISSION CONTROL › PCV VALVE

PCV VALVE > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR FLOOR DECK BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE ENGINE ROOM NO. 2 RELAY BLOCK


    A087418E02
  1. Remove the 2 bolts and relay block.

  1. Remove the 4 wire harness clamps.



6. REMOVE AIR CLEANER ASSEMBLY


A086911E01
  1. Loosen the clamp, then disconnect the No. 1 air cleaner inlet from the air cleaner case.



    A087334E01
  1. Disconnect the mass air flow meter connector, then remove the wire harness clamp.

  1. Loosen the 2 clamps, then remove the 2 bolts and air cleaner assembly.



7. REMOVE WIRE HARNESS


    A087340E01
  1. Disconnect the fuel injector connector and ignition coil connector.

  1. Remove the 3 bolts and wire harness clamp, then disconnect the wire harness.



    A087341E01
  1. Remove the brake master cylinder reservoir cover.



8. REMOVE VENTILATION VALVE


    A128678
  1. Disconnect the ventilation hose.

  1. Remove the ventilation valve.