HEATED OXYGEN SENSOR > REMOVAL |
| 1. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Unlock the 2 washer tank cover knobs, and then remove the rear floor board.
| 2. REMOVE REAR DECK FLOOR BOX |
![]() |
Remove the rear deck floor box from the vehicle.
| 3. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Detach the 4 claws, and then remove the floor board.
| 4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 5. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL |
![]() |
Using a clip remover, remove the clip from the instrument panel finish panel lower center.
Detach the 4 claws and 2 clips, and remove the instrument panel finish panel.
| 6. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() |
Using a clip remover, remove the clip.
Fold back the floor carpet front.
![]() |
Disconnect the sensor connector.
Remove the grommet of the sensor from the vehicle.
![]() |
Remove the wire harness clamp bracket from the sensor.
Using SST, remove the sensor.