FRONT DRIVE SHAFT > REMOVAL |
| 1. DRAIN TRANSAXLE OIL |
Using a 10 mm socket hexagon wrench, remove the drain plug and gasket, and drain the fluid.
Using a socket hexagon wrench, tighten the drain plug with a new gasket placed inside.
| 2. REMOVE FRONT WHEEL |
| 3. REMOVE FRONT AXLE HUB NUT LH |
![]() |
Using SST and a hammer, unstake the axle hub nut.
Using a 30 mm socket wrench, remove the axle hub nut.
| 4. REMOVE FRONT SPEED SENSOR LH |
![]() |
Remove the bolt and disconnect the speed sensor wire and flexible hose clamp from the shock absorber.
![]() |
Remove the bolt and front speed sensor from the steering knuckle.
| 5. DISCONNECT TIE ROD END SUB-ASSEMBLY LH |
![]() |
Remove the clip and castle nut.
Using SST, disconnect the tie rod end from the steering knuckle.
| 6. DISCONNECT NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER LH |
![]() |
Remove the bolt and 2 nuts.
Push down the No. 1 front suspension lower arm and disconnect the front lower ball joint.
| 7. REMOVE FRONT AXLE ASSEMBLY LH |
Using a plastic-faced hammer, tap the end of the front drive shaft and disengage the fitting between the front drive shaft and front axle.
Push the front axle outward from the vehicle to remove the front drive shaft from the front axle.
| 8. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Remove the front fender apron seal.
Hook the SST claw at position (1) in the illustration to remove the front drive shaft.
| 9. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
| 10. FIX FRONT AXLE ASSEMBLY LH |
![]() |
| 11. INSPECT FRONT DRIVE SHAFT ASSEMBLY LH |
Check for noticeable looseness when turning the joint up and down, left and right, and in the thrust direction.
Check for cracks, damage or grease leaks on the joint boot.