Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB BOLT

FRONT AXLE HUB BOLT > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT AXLE HUB BOLT LH
  1. Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.



    F047454E01
  1. Using a screwdriver or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.

  1. Remove the 2 temporary nuts.

    HINT:
    A plate washer of 5 mm (0.21 in.) or more in thickness is preferable.



2. INSTALL FRONT DISC

HINT:
Align the matchmarks of the front disc and front axle hub before installing them.



3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C067088E05
  1. Install the disc brake caliper to the steering knuckle with the 2 bolts.

    Torque:
    137.1 N*m{ 1,398 kgf*cm , 101 ft.*lbf }



4. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }