Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB BOLT

FRONT AXLE HUB BOLT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C067088E05
  1. Remove the 2 bolts and disconnect the disc brake caliper from the steering knuckle.

    NOTICE:
    Hang down the disc brake caliper with a wire or equivalent.



3. REMOVE FRONT DISC

HINT:
Put matchmarks on the front disc and front axle hub.



4. REMOVE FRONT AXLE HUB BOLT LH
  1. Temporarily install 2 nuts to any 2 hub bolts, except the hub bolt that you will replace.



    F047453E01
  1. Using SST and a screwdriver or equivalent to hold the front axle, remove the hub bolt that needs to be replaced.

    SST
    09628-10011