Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING

REAR AXLE HUB AND BEARING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


3. DISCONNECT SKID CONTROL SENSOR CONNECTOR

NOTICE:
Be careful that foreign matter does not attach to the inside of the skid control sensor connector and on the installation portion.



4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH


    C066800E01
  1. Remove the 4 bolts and then remove the axle hub and bearing.