Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR AXLE HUB BOLT LH
  1. Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.



    A125167E02
  1. Using a screwdriver or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.

  1. Remove the 2 temporary nuts.

    HINT:
    A plate washer of 5 mm (0.20 in.) or more in thickness is preferable.



2. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

HINT:
Align the matchmarks of the brake drum and axle hub before installing them.



3. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }