Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

HINT:
Put matchmarks on the brake drum and hub.



3. REMOVE REAR AXLE HUB BOLT LH
  1. Temporarily install 2 nuts to any 2 hub bolts, except hub bolt that you will replace.



    F047468E01
  1. Using SST and a screwdriver or equivalent to hold the front axle, remove the hub bolt that needs to be replaced.

    SST
    09628-10011