Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING

REAR AXLE HUB AND BEARING > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR AXLE HUB BEARING LOOSENESS


    F046836E01
  1. Remove the rear wheel.

  1. Remove the rear brake drum.

    HINT:
    Put matchmarks on the rear brake drum and hub bolt.

  1. Using a dial indicator, check for looseness at the center of the axle hub.

    Maximum looseness:
    0.05 mm (0.0020 in.)

    If the looseness exceeds the maximum, replace the axle hub.



2. INSPECT REAR AXLE HUB BEARING RUNOUT


    F046837E01
  1. Using a dial indicator, check for runout of the axle hub.

    Maximum runout:
    0.07 mm (0.0028 in.)

    If the runout exceeds the maximum, replace the axle hub.

  1. Install the rear brake drum.

    HINT:
    Align the matchmarks of the rear brake drum and hub bolt before installing them.

  1. Install the rear wheel.

    Torque:
    103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }