Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    F046834E01
  1. Remove the front wheel.

  1. Remove the front disc brake caliper.

  1. Remove the front disc.

    HINT:
    Put matchmarks on the front disc and front axle hub.

  1. Using a dial indicator, check for looseness at the center of the axle hub.

    Maximum looseness:
    0.05 mm (0.0020 in.)

    If the looseness exceeds the maximum, replace the axle hub.



2. INSPECT FRONT AXLE HUB RUNOUT


    F046835E01
  1. Using a dial indicator, check for runout of the axle hub.

    Maximum runout:
    0.05 mm (0.0020 in.)

    If the runout exceeds the maximum, replace the axle hub.

  1. Install the front disc.

    HINT:
    Align the matchmarks of the front disc and front axle hub before installing them.

  1. Install the front disc brake caliper.

    Torque:
    137.1 N*m{ 1,398 kgf*cm , 101 ft.*lbf }

  1. Install the front wheel.

    Torque:
    103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }