Home › BODY ELECTRICAL › AUDIO / VISUAL › STEREO COMPONENT AMPLIFIER

STEREO COMPONENT AMPLIFIER > REMOVAL

for Preparation Click here




1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT SEAT ASSEMBLY RH
  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. Remove the 2 bolts on the rear side of the seat.

  1. Disconnect the connectors under the seat. Then remove the front seat.

    NOTICE:
    Be careful not to damage the vehicle body.



3. REMOVE AUDIO AMPLIFIER COVER


    I039615E01
  1. Detach the 2 clips and amplifier cover.



4. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY


    E071459E01
  1. Disconnect the connector.

  1. Remove the 3 bolts and stereo component amplifier.