Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER

FRONT DOOR SPEAKER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH sides.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    B075149E02
  1. Using a screwdriver, detach the 2 clips and remove the garnish.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    I038877E02
  1. Detach the 3 claws and remove the speaker.



3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH


    B076973E06
  1. Using a screwdriver, detach the 3 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE DOOR PULL HANDLE


    B075150E01
  1. Remove the screw and pull handle.



5. REMOVE FRONT ARMREST BASE PANEL UPPER LH


    B075142E03
  1. Driver's side:
    Using a screwdriver, detach the 2 clips and 4 claws, and remove the armrest base panel together with the window regulator master switch.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the switch connector.

  1. Remove the 3 screws and the window regulator master switch from the armrest base panel.



    B075143E03
  1. Passenger's side:
    Using a screwdriver, detach the 2 clips and 4 claws, and remove the armrest base panel together with the 2 switches.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the switch connector.

  1. Using a screwdriver, detach the 2 claws and remove the door control switch.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a screwdriver, detach the 2 claws and remove the power window regulator switch.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B075137E02
  1. Remove the screw.

  1. Using a screwdriver, detach the 7 clips and remove the trim board.

    HINT:
    1. Tape the screwdriver tip before use.
    2. In order to prevent the door panel from being damaged, use protective tape to cover the areas indicated by the arrow marks in the illustration.
    3. If the clip cannot be reached with the screwdriver, pull on the lower trim to remove it.



7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    I036712E01
  1. Disconnect the connector.

  1. Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the speaker.

    NOTICE:
    1. Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
    2. Be careful. The cut rivet is very hot.

  1. Continue drilling and push out the remaining rivet fragments.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.