Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER

REAR DOOR SPEAKER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR SPEAKER ASSEMBLY


    I036713E03
  1. Using an air riveter or hand riveter, install the speaker with 3 new rivets.

    HINT:
    Install the new strike rivets in the order shown in the illustration.

    NOTICE:

    1. H002440E04
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. H002441E03
      Confirm that the rivets are seated properly against the speaker. Do not tilt the riveter when installing the rivet to the speaker. Do not leave any space between the rivet head and speaker.

    3. H002442E03
      Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

  1. Connect the connector.



2. INSTALL REAR NO. 2 SPEAKER ASSEMBLY


    I039619E02
  1. Attach the 3 claws to install the speaker.



3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B075164E03
  1. Attach the 7 clips and install the trim board.

  1. Install the screw.



4. INSTALL REAR DOOR ARMREST BASE PANEL UPPER LH


B075153E03


5. INSTALL DOOR PULL HANDLE


    B075150E01
  1. Install the pull handle with the screw.



6. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH


    B076973E07
  1. Attach the 3 claws to install the bezel.