MICROPHONE AMPLIFIER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE MAP LIGHT ASSEMBLY |
![]() |
Remove the 2 screws.
Using a moulding remover, detach the 4 clips and remove the map light.
Disconnect the map light connector.
| 3. REMOVE MICROPHONE AMPLIFIER ASSEMBLY |
![]() |
Remove the 3 screws and print board.
![]() |
Detach the 4 claws and remove the amplifier cover.
Disconnect the connector.
![]() |
Remove the microphone amplifier.