Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 2 STEERING WHEEL COVER LOWER


3. REMOVE NO. 3 STEERING WHEEL COVER LOWER


4. REMOVE STEERING PAD ASSEMBLY


A125170E04
  1. Straighten the front wheels.

  1. Using a T30 "TORX" socket, loosen the 2 screws until the groove along each screw circumference catches on the screw case.



    H043738E02
  1. Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the 2 airbag connectors.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.



5. REMOVE STEERING PAD SWITCH LH


    I038856E02
  1. Detach the 2 claws and pull out the steering pad switch.

  1. Disconnect the connector and remove the steering pad switch.



6. REMOVE STEERING PAD SWITCH RH


    I038855E02
  1. Detach the 2 claws and pull out the steering pad switch.

  1. Disconnect the connector and remove the steering pad switch.