Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION ECU

NAVIGATION ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT SEAT ASSEMBLY LH
  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. Remove the 2 bolts on the rear side of the seat.

  1. Disconnect the connectors under the seat. Then remove the front seat.

    NOTICE:
    Be careful not to damage the vehicle body.



3. REMOVE NAVIGATION ECU COVER


    I039611E01
  1. Detach the 2 clips and remove the navigation ECU cover.



4. REMOVE NAVIGATION ECU WITH BRACKET
  1. Disconnect the connector.



    I039612E01
  1. Remove the 3 bolts and navigation ECU with bracket.



5. REMOVE NO. 1 DISC PLAYER BRACKET


    I039613E01
  1. Remove the 2 bolts and disc player bracket.



6. REMOVE NO. 2 DISC PLAYER BRACKET


    I039614E01
  1. Remove the 2 bolts and No. 2 disc player bracket.