HYBRID TRANSAXLE SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK TRANSAXLE FLUID LEVEL |
![]() |
Remove the filler plug.
Ensure that the transaxle oil level is within 0 to 5 mm (0 to 0.20 in.) of the filler plug hole.
Check for leaks if the quantity of oil is low.
Install the filler plug with a new gasket.
| 2. INSPECT OIL PRESSURE |
Lift up the vehicle.
![]() |
Remove the fluid pump cover plug and install SST.
Set the blower switch to HI.
Turn the A/C switch on.
Push the power switch with the brake pedal depressed to start the engine (start the hybrid system).
Keeping the engine speed of 1,200 rpm, measure the oil pressure.
![]() |
Install a new O-ring and fluid pump cover plug.
| 3. INSPECT SHIFT LEVER |
![]() |
Inspect the shift lever operation with the hybrid system operating.
Carry the key into the indoor electrical key oscillator detection area or insert the key in the key slot.
Turn the power switch ON (READY ON) while depressing the brake pedal.
Check that the gear changes according to the shift operation pattern. If the check result is abnormal, replace the shift lever assembly.

![]() |
Turn the power switch OFF when the vehicle is stopped.
![]() |
Inspect the shift lever operation with the power switch's power mode ON (IG).
Carry the key into the indoor electrical key oscillator detection area or insert the key in the key slot.
![]() |
Turn the power switch ON (IG) without depressing the brake pedal.
Check that the gear changes according to the shift operation pattern. If the check result is not as specified, replace the shift lever assembly.
