Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › HYBRID VEHICLE TRANSAXLE UNIT

HYBRID VEHICLE TRANSAXLE UNIT > INSPECTION

for Preparation Click here



1. INSPECT HV MOTOR ASSEMBLY


    C069413E01
  1. Inspect the inside diameter of the rotor bush.

    1. Using a caliper gauge, measure the inside diameter of the motor rotor bush.

      Standard diameter:
      20.025 to 20.046 mm (0.7884 to 0.7892 in.)

      Maximum diameter:
      20.096 mm (0.7912 in.)

      NOTICE:
      Take the measurement in different locations and use the average of the measurements taken.

      If the inside diameter exceeds the maximum, replace the motor assembly with a new one.