Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › INPUT SHAFT

INPUT SHAFT > INSPECTION

for Preparation Click here



1. INSPECT PLANETARY SUN GEAR SUB-ASSEMBLY
  1. Ensure that there is no damage or color change in the bush.



    C069344E01
    C069345E01
  1. Using a caliper gauge, inspect the internal diameter of the planetary gear.

    Maximum diameter:
    25.596 mm (1.0077 in.)

    NOTICE:
    Measure the diameter in a number of locations and use the average of the measurements taken.

    HINT:
    Replace the planetary sun gear with a new one if the measurement exceeds the maximum diameter.



2. INSPECT INPUT SHAFT THRUST NEEDLE ROLLER NO. 1 BEARING


    C069286E01
  1. Ensure that there is no abnormal wear or discoloration in the bearing.

    HINT:
    Replace the input shaft thrust needle roller bearing with a new one if there is abnormal wear or discoloration.