Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › DIFFERENTIAL DRIVE PINION

DIFFERENTIAL DRIVE PINION > DISASSEMBLY

for Preparation Click here



1. REMOVE COUNTER DRIVE GEAR RADIAL BALL BEARING


    C099559E01
  1. Loosen the staked part of the nut.



    G030576E01
  1. Set the differential drive pinion in a vise and remove the nut using a deep socket wrench.

    HINT:
    Set the drive pinion in a vise as shown in the illustration.



    G030577E01
  1. Using SST and a press, press out the bearing from the differential driver pinion.

    SST
    09527-10011  
    09950-00020  
    09950-60010   (09951-00360)
    09950-70010   (09951-07100)



    G030578E01
  1. Using SST and a press, press out the bearing from the differential drive pinion.

    SST
    09527-10011  
    09950-00020  
    09950-60010   (09951-00360)
    09950-70010   (09951-07100)