DIFFERENTIAL CASE > DISASSEMBLY |
| 1. REMOVE DIFFERENTIAL CASE LH TAPERED ROLLER BEARING |
![]() |
Set the differential case in a vise.
Using SST, remove the bearing RH from the differential case.
| 2. REMOVE DIFFERENTIAL CASE RH TAPERED ROLLER BEARING |
![]() |
Set the differential case in a vise.
Using SST, remove the bearing LH from the differential case.
| 3. REMOVE DIFFERENTIAL CASE |
![]() |
Set the differential case in a vise.
Tap out the straight pin from the differential case with a 5 mm pin punch.
![]() |
Remove the following parts from the differential case.
| Number | Part | Number of Parts |
| 1 | Pinion shaft | 1 |
| 2 | Pinion | 2 |
| 3 | Pinion thrust washer | 2 |
| 4 | Side gear | 2 |
| 5 | Side gear thrust washer | 2 |