DIFFERENTIAL CASE > REASSEMBLY |
| 1. INSTALL DIFFERENTIAL CASE |
![]() |
Apply ATF WS to the side gear thrust washer and install it to the side gear.
Apply ATF WS to the side gear thrust washer and install it to the pinion.
Install the side gear and pinion to the differential case.
Install the pinion shaft to the differential case so that the straight pin holes of the pinion shaft and differential case are aligned.
![]() |
Set the pinion side and inspect the side gear backlash.
| Part No. | Washer thickness |
| 41361-22140 | 0.95 mm (0.0374 in.) |
| 41361-22020 | 1.00 mm (0.0394 in.) |
| 41361-22150 | 1.05 mm (0.0414 in.) |
| 41361-22030 | 1.10 mm (0.0433 in.) |
| 41361-22160 | 1.15 mm (0.0453 in.) |
| 41361-22040 | 1.20 mm (0.0472 in.) |
![]() |
Using a 5 mm pin punch, tap in the straight pin to the differential case.
![]() |
Using a chisel, caulk the external circumference of the differential case straight pin hole.
| 2. INSTALL DIFFERENTIAL CASE RH TAPERED ROLLER BEARING |
![]() |
Using SST and a press, press in the bearing RH to the differential case.
| 3. INSTALL DIFFERENTIAL CASE LH TAPERED ROLLER BEARING |
![]() |
Using SST and a press, press in the bearing LH to the differential case.