Home › BODY › INTERIOR › FUEL LID LOCK CONTROL

FUEL LID LOCK CONTROL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the seat (Click here).



3. REMOVE REAR SEAT CUSHION ASSEMBLY


    B132600E01
  1. Detach the seat cushion's 2 front hooks from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat for the other hook.

  1. Detach the seat cushion's rear hook.

  1. Remove the seat cushion.



4. REMOVE REAR SIDE SEATBACK ASSEMBLY LH
  1. Remove the bolt and side seatback.



5. REMOVE FRONT DOOR SCUFF PLATE LH


    B073586E02
  1. Using a screwdriver, detach the 8 claws and 2 clips, and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE REAR DOOR SCUFF PLATE LH


    B073587E02
  1. Using a screwdriver, detach the 6 claws and clip, and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE CENTER PILLAR LOWER GARNISH LH


    B073589E03
  1. Using a screwdriver, detach the 2 claws and 2 clips, and remove the lower garnish.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    B073591E02
  1. Remove the screw and 2 bolts.

  1. Using a clip remover, remove the clip.

  1. Using a screwdriver, detach the 7 claws and 3 clips, and remove the side panel.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH


    B073592E03
  1. Using a screwdriver, detach the 6 clips and claw, and remove the inner garnish.

    HINT:
    Tape the screwdriver tip before use.



10. REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY


    B074573E01
  1. Remove the screw while holding the lever.

  1. Disconnect the cable and remove the lever.



11. REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY


  1. Disconnect the cable from the clamps at the location shown in the illustration.


    B075120E02



    B073318E04
  1. Push the claw and pull out the cable.



12. REMOVE FUEL FILLER OPENING LID LOCK RETAINER


    B073319E02
  1. Turn the lock retainer counterclockwise and remove the lock retainer as shown in the illustration.