Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Multi-display Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the multi-display.

WIRING DIAGRAM


E107218E05


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B, ACC)
  1. Disconnect the ECU-B and ACC fuses from the driver side junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (MULTI-DISPLAY - BATTERY AND BODY GROUND)


    B118155E20
  1. Disconnect the M13 connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    M13-1 (GND1) - Body ground*1
    Below 1 Ω
    M13-3 (GND1) - Body ground*2
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    M13-2 (ACC) - Body ground*1
    Power switch ON (ACC)
    10 to 14 V
    M13-3 (+B1) - Body ground*1
    Always
    10 to 14 V
    M13-11 (ACC) - Body ground*2
    Power switch ON (ACC)
    10 to 14 V
    M13-12 (+B1) - Body ground*2
    Always
    10 to 14 V

HINT:
  1. *1: for 4 Connector type
  2. *2: for 3 Connector type



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE