WIPER AND WASHER SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY |
Operation Check
![]() |
Fill the washer jar with washer fluid.
Connect the positive battery (+) lead to terminal 1 of the windshield washer motor and pump, and the negative battery (-) lead to terminal 2. Check that washer fluid flows from the washer jar.
| 2. INSPECT REAR WASHER MOTOR (w/ Rear Wiper) |
![]() |
Operation Check
Fill the washer jar with washer fluid.
Connect the positive battery (+) lead to terminal 1 of the windshield washer motor and pump, and the negative battery (-) lead to terminal 2. Check that washer fluid flows from the washer jar.
| 3. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY |
![]() |
Automatic Stop Position Inspection
Operate the windshield wiper motor, and then stop the operation.
Check the automatic stop position when stopping the windshield wiper motor operation.
| 4. INSPECT REAR WIPER MOTOR ASSEMBLY |
![]() |
Automatic Stop Position Inspection
Operate the rear wiper motor, and then stop the operation.
Check the automatic stop position when stopping the rear wiper motor operation.