Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR AND LINK

FRONT WIPER MOTOR AND LINK > REMOVAL

for Preparation Click here



1. REMOVE FRONT WIPER ARM HEAD CAP


2. REMOVE FRONT WIPER ARM LH
  1. Remove the 2 nuts and FR wiper arm LH.



3. REMOVE FRONT WIPER ARM RH
  1. Remove the nut and FR wiper arm RH.



4. REMOVE HOOD TO COWL TOP SEAL


    I038368E02
  1. Detach the 8 clips and remove the hood to cowl top seal.



5. REMOVE COWL TOP VENTILATOR LOUVER LH


    I038369E02
  1. Detach the 8 claws and clip, and remove the cowl top ventilator louver LH.



6. REMOVE COWL TOP VENTILATOR LOUVER RH


    I038370E02
  1. Detach the 8 claws and clip, and remove the cowl top ventilator louver RH.



7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    I038371E01
  1. Disconnect the connector.

  1. Remove the 5 bolts and wiper motor & link.



8. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    I038372E01
  1. Using a flat-head screwdriver, disengage the windshield wiper link arm from the crank arm pivot of the windshield wiper motor.

    HINT:
    Tape the screwdriver tip before use.



    I038383E01
  1. Remove the nut and washer.



    I038384E02
  1. Remove the crank arm.

  1. Put matchmarks on the crank arm and windshield wiper motor, and remove the crank arm (when reinstalling).



    I038385E01
  1. Remove the 3 bolts and the windshield wiper motor.