Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR WIPER ARM COVER


3. REMOVE REAR WIPER ARM ASSEMBLY
  1. Remove the nut and rear wiper arm.



4. REMOVE BACK DOOR LOWER TRIM BOARD ASSEMBLY
  1. Using a screwdriver, detach the 11 clips and remove the lower trim board.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE REAR WIPER MOTOR ASSEMBLY


    I038386E01
  1. Disconnect the connector.

  1. Remove the 3 bolts and rear wiper motor.