Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER NOZZLE

WASHER NOZZLE > ADJUSTMENT

for Preparation Click here



1. INSPECT WASHER NOZZLE


  1. With the power switch ON (IG), check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas indicated in the illustration.



    B139879E01



    B139880E02



2. ADJUST WASHER NOZZLE


  1. Using a TOYOTA 4 Way Nozzle Adjustment Tool, insert the bumpy part of the adjustment tool into the bumpy part of the nozzle jet and make the adjustment.

    NOTICE:
    1. Clarify if the 4 mm or 5 mm diameter washer nozzle is being adjusted.
    2. Do not use a tool such as metal pin as it may damage the nozzle jet.



    I040986E01