Home › BODY ELECTRICAL › LIGHTING › HIGH MOUNTED STOP LIGHT ASSEMBLY

HIGH MOUNTED STOP LIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK CENTER STOP LIGHT ASSEMBLY


    E072841E01
  1. Disconnect the H19 light connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Brake pedal pressed
    Below 1 V
    1 - 2
    Brake pedal depressed
    10 to 14 V