NAVIGATION SYSTEM > Vehicle Speed Signal Circuit between Navigation ECU and Combination Meter |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (NAVIGATION ECU - COMBINATION METER) |
![]() |
Disconnect the N3 ECU connector.
Disconnect the C10 meter connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| N3-4 (SPD) - C10-13 | Below 1 Ω |
| N3-4 (SPD) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||