Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


    E068152E14
  1. Inspect the light control switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      12 - 18
      OFF
      10 kΩ or higher
      12 - 19
      12 - 20
      12 - 18
      TAIL
      Below 1 Ω
      12 - 18
      12 - 20
      HEAD
      Below 1 Ω
      12 - 19
      AUTO
      Below 1 Ω

      If the result is not as specified, replace the switch assembly.

  1. Inspect the headlight dimmer switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      11 - 12
      FLASH
      Below 1 Ω
      11 - 17
      12 - 16
      LOW BEAM
      Below 1 Ω
      11 - 12
      HIGH BEAM
      Below 1 Ω

      If the result is not as specified, replace the switch assembly.

  1. Inspect the turn signal switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      12 - 13
      Right turn
      Below 1 Ω
      12 - 13
      Neutral
      10 kΩ or higher
      12 - 15
      12 - 15
      Left turn
      Below 1 Ω

      If the result is not as specified, replace the switch assembly.

  1. Inspect the fog light switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester connection
      Condition
      Specified condition
      3 - 4
      OFF
      10 kΩ or higher
      3 - 4
      Front fog light switch ON
      Below 1 Ω

      If the result is not as specified, replace the switch assembly.