Home › BODY ELECTRICAL › LIGHTING › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E072840E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 3
    Hazard warning switch ON
    Below 1 Ω
    2 - 3
    Hazard warning switch OFF
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.

  1. Connect the battery positive (+) lead from the battery to terminal 4 and battery negative (-) lead to terminal 1, then check that the illumination comes on.

    OK:
    Illumination comes on.

    If the result is not as specified, replace the switch assembly.