Home › BODY ELECTRICAL › LIGHTING › MAP LIGHT ASSEMBLY

MAP LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


    E072839E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 3
    1 - 4
    Switch is OFF
    10 kΩ or higher

    If the result is not as specified, replace the light assembly.

  1. Connect the battery positive (+) lead from the battery to terminal 1 and battery negative (-) lead to terminal 3, then check that the illumination comes on when the switch is in the DOOR position.

    OK:
    Illumination comes on.

    If the result is not as specified, replace the light assembly.

  1. Connect the battery positive (+) lead from the battery to terminal 1 and battery negative (-) lead to terminal 4, then check that the illumination comes on when the switch is in the ON position.

    OK:
    Illumination comes on.

    If the result is not as specified, replace the light assembly.