Home › BODY ELECTRICAL › LIGHTING › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > INSPECTION

for Preparation Click here



1. INSPECT HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    I039980E03
  1. Connect 3 dry cell batteries (1.5 V) in a series.

  1. Connect the positive (+) lead from the batteries to terminal 3 and negative (-) lead to terminal 1.

  1. Measure the voltage between the terminal 1 and 2 when slowly move the link up and down.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    +45° (High)
    Approx. 4.5 V
    1 - 2
    0° (Normal)
    Approx. 2.5 V
    1 - 2
    -45° (Low)
    Approx. 0.5 V

    If the result is not as specified, replace the sensor sub-assembly.