Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH ASSEMBLY


    E065594E13
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Switch pin not pushed
    Below 1 Ω
    3 - 4
    Switch pin not pushed
    10 kΩ or higher
    1 - 2
    Switch pin pushed
    10 kΩ or higher
    3 - 4
    Switch pin pushed
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.